Subaru 2008 Forester 2.5X User Manual
Page 103
Black plate (104,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
2-14
Keys and doors
: Press to Arm the system.
: Press to Disarm the system.
Security indicator light
6. Briefly press the
“ ” button (for less
than 2 seconds). All doors and the rear
gate will lock, an electric chirp will sound
once, the turn signal lights will flash once,
and the indicator lights will start flashing
rapidly. After rapid flashing for 30 seconds
(standby time), the indicator lights will then
flash slowly (twice approximately every 2
seconds), indicating that the system has
been armed for surveillance.
If any of the doors or the rear gate is not
fully closed, an electronic chirp sounds 5
times, the turn signal lights flash 5 times to
alert you that the doors or the rear gate
are not properly closed. When you close
the door, the system will automatically arm
and doors will automatically lock.
! To arm the system using power
door locking switches
1. Close all windows.
2. Remove the key from the ignition
switch.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close the doors and the rear gate but
leave only the driver
’s door or the front
passenger
’s door open.
6. Push the front side (
“LOCK” side) of
the power door locking switch to set the
door locks.
7. Close the door. An electronic chirp will
sound once, the turn signal lights will flash
once, and the indicator lights will start
flashing rapidly. After rapid flashing for 30
seconds (standby time), the indicator
lights will then flash slowly (twice approxi-
mately every 2 seconds), indicating that
the system has been armed for surveil-
lance.
NOTE
. The system can be armed even if the
engine hood, the windows and/or
moonroof are opened. Always make
sure that they are fully closed before
arming the system.