Subaru 2008 Forester 2.5X - Manual (Page 163)

Black plate (170,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
5-6
Audio
! FM/AM band selection button
(BAND)
Push the “BAND” button when the radio is
on to select FM1, FM2 or AM band
reception. Each time this button is
pressed, the band will change in the
following order:
The display indicates which one is cur-
rently selected.
! Stereo indicator
The stereo indicator
“ST” will come on
when an FM stereo broadcast is received.
! Tuning (TUNE)
! Manual tuning (TUNE)
Push the
“ ” side of the tuning button (3)
to increase the tuning frequency and
press the
“ ” side of the button to
decrease it.
Each time the button is pressed, the
frequency changes 10 kHz in the AM
waveband and 0.2 MHz in the FM wave-
band.
! Seek tuning
If the tuning button (3) is pressed for
longer than half of a second, the radio will
begin to automatically search for receiva-
ble frequencies and will stop at the first
one found. This function may not be
available, however, when radio signals
are weak. In such a situation, perform
manual tuning to select the desired
station.
! Automatic tuning (SCAN)
Press the
“SCAN” button (6) to change the
radio to the SCAN mode. In this mode, the
radio scans through the radio band until a
station is found. The radio will stop at the
station for 5 seconds while displaying the
frequency, after which scanning will con-
tinue until the entire band has been
scanned from the low end to the high end.
Press the
“SCAN” button again to cancel
the SCAN mode and to stop on any
displayed frequency.
When the
“SCAN” button is pressed for
automatic tuning, stations are scanned in
the direction of low frequencies to high
frequencies only.
Automatic tuning may not function prop-
erly if the station reception is weakened by
distance from the station or proximity to
tall buildings and hills.
! Selecting preset stations
Presetting a station with a preset button
(4) allows you to select that station in a
single operation. Up to six AM, FM1 and
FM2 stations each may be preset.
! How to preset stations
1. Press the
“BAND” selection button to
select AM, FM1 or FM2 reception.
2. Press the
“SCAN” button (6) or tune
the radio manually until the desired station
frequency is displayed.
3. Press one of the preset buttons (4) for
at least 2 seconds to store the frequency.
At this time, there will momentarily be no
sound from the radio. If the button is
pressed for less than 2 seconds, the
preceding selection will remain in memory.
NOTE
. If the connection between the radio
and battery is broken for any reason
such as vehicle maintenance or radio
removal, all stations stored in the
preset buttons are cleared. If this
occurs, it is necessary to reset the
preset buttons.
. If a cell phone is placed near the
radio, it may cause the radio to emit
noise when it receives calls. This noise
does not indicate a radio fault.