Dynex DX-24L200A12 - Manual (Page 15)

Making connections
11
DX-24L200A12
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the back of your TV and to
the antenna or cable TV wall jack.
3 Turn on your TV, then go through the setup wizard
on page 17.
Connecting a DVD or Blu-ray player
Using HDMI
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV’s power cord is unplugged
and the DVD or Blu-ray player is turned off.
2 Connect an HDMI cable (not provided) to one of the
HDMI1 or HDMI2 jacks on the back of your TV and
to the HDMI OUT jack on the DVD or Blu-ray player.
To play from a DVD or Blu-ray player:
1 Turn on your TV, then press INPUT to open the
INPUT SOURCE list.
2 Press or to select HDMI, then press ENTER.
3 Turn on the DVD or Blu-ray player.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
Y P B P R L - AUDIO - R
COMPONENT IN
ANT / CABLE
AV IN
VIDEO HDMI 2 HDMI 1 / DVI VGA PC / DVI
AUDIO IN DIGITAL
OUTPUT SERVICE PORT
Back of TV
Coaxial cable
Note
You can also press HDMI one or more times to select
HDMI1 or HDMI2.
Y P B P R L - AUDIO - R
COMPONENT IN
ANT / CABLE
AV IN
VIDEO HDMI 2 HDMI 1 / DVI VGA PC / DVI
AUDIO IN DIGITAL
OUTPUT SERVICE PORT
Back of TV
DVD or Blu-ray player
HDMI cable
DX-24L200A12_11-0584_MAN_ENG_V1.book Page 11 Wednesday, September 14, 2011 12:59 PM