Dynex DX-24L200A12 - Manual (Page 14)

10
Making connections DX-24L200A12
Using composite video (good)
To connect a cable or satellite box using composite
video:
1 Turn off your TV and all connected equipment.
2 Connect the incoming cable from the cable wall jack
to the cable-in jack on the cable or satellite box.
3 Connect a composite cable (provided) to the VIDEO,
L, and R jacks on the back of your TV and to the
composite video and audio out jacks on the cable or
satellite box.
4 Turn on your TV, then turn on the cable or satellite
box.
5 Go through the setup wizard on page 17.
Using coaxial (good)
To connect a cable or satellite box using coaxial:
1 Turn off your TV and all connected equipment.
2 Connect the incoming cable from the cable wall jack
to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the side of your TV and to the
coaxial out jack on the cable or satellite box.
4 Turn on your TV, then turn on the cable or satellite
box.
5 Go through the setup wizard on page 17.
Y P B P R L - AUDIO - R
COMPONENT IN
ANT / CABLE
AV IN
VIDEO HDMI 2 HDMI 1 / DVI VGA PC / DVI
AUDIO IN DIGITAL
OUTPUT SERVICE PORT
Back of TV
Cable or satellite box
Composite cable
Cables are often
color-coded to match
color-coded jacks.
75 ohm coaxial cable
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
Y P B P R L - AUDIO - R
COMPONENT IN
ANT / CABLE
AV IN
VIDEO HDMI 2 HDMI 1 / DVI VGA PC / DVI
AUDIO IN DIGITAL
OUTPUT SERVICE PORT
Cable or satellite box
Back of TV
Coaxial cable
75 ohm coaxial cable
DX-24L200A12_11-0584_MAN_ENG_V1.book Page 10 Wednesday, September 14, 2011 12:59 PM