Subaru 2012 Impreza User Manual
Page 136
Black plate (144,1)
北米Model "A1120BE-B" EDITED: 2011/ 10/ 28
3-22
Instruments and controls
&
Shift-up indicator light
(MT models)
While driving, this indicator light illumi-
nates and informs the driver about the
upshift timing for fuel-efficient driving.
The shift-up indicator can be activated or
deactivated by performing the following
procedure.
1. Turn the ignition switch to the
“LOCK”
or
“ACC” position.
2. Press the trip knob to show
“
” or
“
” on the trip meter display.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
*
1
: They cannot be displayed when the
ignition switch is in the
“ON” position.
*
2
: MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. The initial setting for the shift-up
indicator has been set for activation
“
” at the time of shipment from the
factory.
. It is not possible to change the
setting of the shift-up indicator when
the ignition switch is in the
“ON”
position. Change the setting when the
ignition switch is in the
“LOCK” or
“ACC” position.
& Select lever/gear position in-
dicator (CVT models)
1)
Upshift indicator
2)
Downshift indicator
This indicator shows the position of the
select lever.
For models with manual mode, when the
manual mode is selected, the gear posi-
tion indicator (which shows the current
gear selection) and the upshift/downshift
indicator light up. Refer to
“Continuously
variable transmission
” F7-18.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.