Saab 2006 9-2 - Manual (Page 193)

Starting and operating
7-21
7
– CONTINUED –
Cruise control
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 25
mph (40 km/h) or more. Make sure the
main switch is turned “OFF” when the
cruise control is not in use to avoid unin-
tentionally setting the cruise control.
NOTE
If you move the cruise control lever or
press the main switch button while
turning the ignition switch “ON”, the
cruise control function is deactivated
and the “CRUISE” indicator light flash-
es. To reactivate the cruise control
function, turn the ignition switch back
to the “ACC” or “LOCK” position, and
then turn it again to the “ON” position.
¢ To set cruise control
0
1. Push the main switch button.
The “ ” indicator light on the instru-
ment cluster will come on.
2. Depress the accelerator pedal until the
vehicle reaches the desired speed.
3. Push the control lever downward in the
“SET/COAST” direction and release it.
Then release the accelerator pedal.
At this time, the “ ” indicator light is
illuminated in the instrument cluster.
Do not use the cruise control under
any of the following conditions. This
may cause loss of vehicle control:
— driving up or down a steep grade
— driving in the rain or on slippery or
winding roads
— driving in heavy traffic
300332
700361
300333
700362
A1910BE-A-GSAAB.book Page 21 Tuesday, September 6, 2005 8:37 AM