Prac tic a l interio r ac cess o r ie s – Mini 2011 Cooper Convertible User Manual

Page 86

Prac

tic

l interio

cess

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
You can operate the system with the engine
running or with the ignition switched on.

If the system fails to function even after
repeated programming, check whether

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button 1 of the integrated universal remote con-
trol. If the LED 2 on the integrated universal
remote control flashes rapidly and then remains
lit for about two seconds, the original hand-held
transmitter uses an alternating-code system. If it
uses an alternating-code system, program the
memory buttons 1 as described under Alternat-
ing-code hand-held transmitters.

Alternating-code hand-held
transmitters

To program the integrated universal remote
control, consult the operating instructions for
the device to be set. You will find information
there on the possibilities for synchronization or
programming of additional hand-held transmit-
ters.
When programming hand-held transmitters that
employ an alternating code, please observe the
following supplementary instructions:

Programming will be easier with the aid of
a second person.

Park your vehicle within the range of the
remote-controlled device.

Do not exceed a distance of 50 m from
the radio remote controlled device.

Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.

Locate the button on the receiver of the
device to be set, e.g. on the drive unit.

Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for the next step 5.

Press the programmed memory button 1 of
the integrated universal remote control
three times.

The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.

Clearing stored programs

Press both outer memory buttons 1 for approx.
20 seconds until the LED 2 flashes: all stored
programs are cleared.
It is not possible to clear individual programs.

Reassigning individual programs

Hold the original hand-held transmitter at a
distance of approx. 2 in to 12 in/5 to 30 cm
from the memory buttons 1.

The required distance between the
hand-held transmitter and the mem-

ory buttons 1 depends on the system of the
respective original hand-held transmitter
used.

Press the desired memory button 1 of the
integrated universal remote control.

If the LED 2 flashes slowly after approx.
20 seconds, press the transmit key of the
original hand-held transmitter and release
both buttons as soon as the LED 2 flashes
rapidly.
If the LED 2 does not flash rapidly after
approx. 15 seconds, alter the distance and
repeat this step.