Starting the engine, Switching off the engine, Parking brake – Mini 2011 Cooper Convertible User Manual
Page 47
45
CO
M
M
U
N
ICA
T
IO
N
S
Starting the engine
Do not allow the engine to run in enclosed
areas; otherwise, inhalation of the noxious
exhaust gases can lead to loss of consciousness
and death. Exhaust gases contain carbon mon-
oxide, an odorless and colorless, but highly toxic
gas. Never leave an unattended vehicle with the
engine running; otherwise, such a vehicle repre-
sents a potential safety hazard.
Before leaving the car while the engine is run-
ning, place the transmission in neutral or move
the selector lever to position P and forcefully
apply the parking brake to prevent the car from
moving.
<
Avoid frequent starting in quick succes-
sion or repeated start attempts in which
the engine does not start. Otherwise, the fuel is
not burned or inadequately burned and there is
a danger of overheating and damaging the cat-
alytic converter.
<
Do not let the engine warm up with the vehicle
at a standstill. Move off immediately at a moder-
ate engine speed.
When starting the engine, do not depress the
accelerator pedal.
Manual transmission
Key in ignition lock or inside vehicle with Com-
fort Access, refer to page
.
1.
Depress the brake.
2.
Depress the clutch.
3.
Press the Start/Stop button.
Automatic transmission*
Key in ignition lock or inside vehicle with Com-
fort Access, refer to page
.
1.
Depress the brake.
2.
Shift the selector lever into position P or N.
3.
Press the Start/Stop button.
The starter operates automatically for a certain
time, and stops automatically as soon as the
engine has started.
Switching off the engine
Always take the key with you when you
leave the vehicle.
When parking, apply the parking brake force-
fully; otherwise, the vehicle could begin to roll.
<
Manual transmission
1.
With the car at a standstill, press the Start/
Stop button.
2.
Shift into first gear or reverse.
3.
Forcefully apply the parking brake.
Automatic transmission*
1.
With the car at a stop, move the selector
lever to position P.
2.
Press the Start/Stop button.
3.
Forcefully apply the parking brake.
Before driving into a car wash
By following these steps, the vehicle is able to
roll:
1.
Place the remote control, even with Comfort
Access, in the ignition lock.
2.
Depress the brake.
3.
Move the selector lever to position N.
4.
Switch off the engine.
Parking brake
The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked; it
brakes the rear wheels.
Applying
The lever locks in position automatically.
Online Edition for Part no. 01 40 2 605 657 - © 07/10 BMW AG
Online Edition for Part no. 01 40 2 605 657 - © 07/10 BMW AG