Denon S-101 - Manual (Page 52)

49
ENGLISH
System Setup System Setup
ENGLISH
2 Press the CURSOR • or ª button to select
“DISTANCE”, then press the ENTER button.
• The distance setting screen appears.
3 Press the CURSOR 0 or 1 button to select
“FEET” or “METERS” for the “DISTANCE”
mode, then press the
CURSOR ª button.
4 Press the CURSOR • or ª button to select the
speaker, then press the CURSOR 0 or 1 button
to set the distance between the speaker and the
listening position.
• The distance changes by 1 foot (or 0.1 meters when the
unit is set to feet) each time the CURSOR 0 0 or 1 1 button
is pressed. Select the value closest to the measured
distance.
Make sure the difference in the distances set for the
various speakers is no greater than 15 feet (4.5 meters).
If an inappropriate distance is set, “CAUTION: INVALID
DISTANCE” is displayed. Change the position of the
speaker and make the setting over.
To set the distance of the various speakers back to their
default values, press the CURSOR
• or ª button to select
“DEFAULT” then press the ENTER button.
Setting “SPEAKER LOCATION”
The optimum acoustics can be achieved by setting the location
of the speakers and the conditions in the room.
1
Press the CURSOR • or ª button to select
“SPEAKER SETUP” at the “AUDIO SETUP”,
then press the
ENTER button.
• The “SPEAKER SETUP” screen appears.
2
Press the CURSOR • or ª button to select
“SPEAKER LOCATION”, then press the
ENTER button.
• The speaker locations setting screen appears.
LOCATION:
Select the speaker setting location.
ROOM DAMPING:
Select the reverberation of the sound in the room in which the
speakers are located.
3 Press the CURSOR 0 or 1 button to select “1”,
“2” or “3” for the “LOCATION” mode, then
press the
CURSOR ª button.
• The “SPEAKER SETUP” screen appears.
1 (ON WALL):
Select this when satellite speakers are installed on the walls
or when there is a wall directly behind the speakers.
2 (ON SHELF) (Factory default):
Select this when the speakers are installed on a table or rack
using the included speaker stands.
3 (FREE STANDING):
Select this when a separately sold floor stand is installed.
Select “ON WALL” when there is a wall directly behind the
speakers, regardless of the “ON SHELF” or “FREE
STANDING” setting.
5 Press the CURSOR ª button to select “SETUP
MENU”, then press the ENTER button.
• The “SPEAKER SETUP” screen appears.
6 Press the CURSOR ª button to select “NEXT
SETUP MENU”, then press the ENTER to enter
the setting.
• The next screen in the “SETUP” menu screen appears.