Dixon SilverTip ZTR 72 - Manual (Page 43)

CARE AND MAINTENANCE
43
PARKING BRAKE ADJUSTMENT
1. Raise rear of machine.
2. Remove tire and wheel assembly.
3. Adjust the 3/8” adjustment nut clockwise to
increase and counter-clockwise to decrease
brake holding power. As the brake holding
power is increased, the force required on the
handle to engage the brake increases.
4. Set the brake for the holding power required
for the intended use and the desired force
required to activate it.
5. Install wheel & tire assembly.
6. Repeat steps 2-5 for opposite side.