Controls, Mower blade switch, Ignition switch – Dixon SilverTip ZTR 72 User Manual
Page 20: Choke control lever, Throttle control lever, Circuit breaker
CONTROLS
20
MOWER BLADE SWITCH:
To engage blades: pull up on switch
To disengage blades: push down
IGNITION SWITCH:
•
Turn to start position to crank engine.
Release when it starts.
•
For headlights - rotate switch one notch
counter-clockwise from run.
Note: Remove key when mower is not in use.
CHOKE CONTROL LEVER:
•
Located on the control panel to the operator’s right.
THROTTLE CONTROL LEVER:
•
Located on control panel to operator’s right.
•
Controls engine speed.
•
While mowing, throttle control should be set to MAXIMUM
or wide open setting to insure adequate cooling of the
engine and to maintain mower deck blade speed.
CIRCUIT BREAKER:
•
If circuit breaker pops up, it disconnects the power. Wait 2
minutes and push to reset.
•
If it pops up again, there is a short circuit. Stop and find
fault or contact your dealer.