7 external storage, 1 usb storage devices, 2 network shares – Naim Audio UnitiServe User Manual
Page 22: 3 music stores, Operation - exter nal storage

20
Operation - Exter nal Storage
7 External Storage
UnitiServe is not only able to replay material ripped and stored on its internal hard disk but 
can also replay material stored on a variety of externally connected storage hardware. 
Such hardware might be relatively small capacity devices temporarily connected via one 
of UnitiServe’s USB interface sockets, or large capacity “Network Shares” connected via a 
home network. Network Shares can also be configured as UnitiServe rip locations.
7.1 USB Storage Devices
A locally connected storage device will most likely be a 
memory stick connected to one of UnitiServe’s USB sockets.
Note:
The amount of music stored on an external device
determines how long UnitiServe will spend scanning the 
device when it is first connected before the music is 
available to browse.
Note:
Locally connected devices are re-scanned every
time UnitiServe starts up.
The tracks found by UnitiServe on locally connected 
storage will only be held in its database while the storage is 
connected and switched on.
Note:
Local connection is only intended for relatively small
music collections on temporarily connected memory sticks. 
Any large capacity storage should always be connected 
via a network.
In order for USB stored music to be available to UnitiServe, 
for playback various conditions must be met:
•
 Music files must be in AAC, FLAC, MP3, or WAV 
formats (up to 24 bit, 192kHz).
•
 Music files must be unprotected by DRM encoding 
that restricts them to specific playback hardware.
7.2 Network Shares
Before material stored on shared network devices can be 
accessed by UnitiServe, it must scan the network to identify 
the address of each share and to build a database of the 
locations and details of the available audio files.
UnitiServe automatically scans the network when first 
switched on and will then periodically scan to find new 
network shares and identify any changes to the available 
audio files. It may however take a considerable time 
following connection of UnitiServe to the network for 
changes to be reflected in UnitiServe’s database.
Note:
Network scanning is carried out at up to several
hundred files per minute although this figure depends on 
the speed of the file storage device.
The music files found by UnitiServe on network shares will 
be incorporated into its database and remembered until 
any changes are identified, irrespective of UnitiServe being 
switched off.
In order for network shared music files to be available to 
UnitiServe, for network or local playback various conditions 
must be met:
•
 Folders containing audio files must be set up to 
be “shared”. Refer to the folder’s host computer 
operating system user manual for details on setting 
up shared folders.
•
 Music files must be in AAC, FLAC, MP3, WAV, Apple 
Lossless, Ogg, AIFF or WMA formats (up to 24 bit, 
192kHz).
•
 Music files must be unprotected by DRM encoding 
that restricts them to specific playback hardware.
Network shares can be viewed and managed from the 
Display Interface Network Shares menu. See Section 4.8.3
7.3 Music Stores
Network Shares can be converted to operate as UnitiServe 
Music Stores – locations where the data from ripped 
CDs is stored. Promoting a Network Share to Music Store 
status may be appropriate if the internal UnitiServe drive is 
becoming full or if external rip storage provides enhanced 
network convenience or data security.
Note:
Enhanced data security is only likely if the network
share is a RAID device.
Just as UnitiServe’s internal hard disk does not appear as 
a Network Share, when a Network Share is converted to 
Music Store status it will no longer appear in UnitiServe’s 
Network Shares list.
Music Stores are used as rip locations by UnitiServe in order 
of priority. CDs will be ripped automatically to the highest 
priority Music Store until it is full, when the next priority Music 
Store will be used.
Network Shares can be converted to Music Store status 
via the 
Add New Store
option of the
Music Stores Menu
.
See the following section and Section 4.8.4 for more 
information on Music Stores.
Important: Files should never be added to or deleted from 
Music Stores via an alternative computer operating system.
Note:
This is because Music Stores contain not only the
ripped CD data files but also the associated database and 
metadata files. External manipulation of a Music Store will 
almost certainly result in database or metadata corruption.
