Nexen XTB 10-18 Dual Disc Caliper 835500 - Manual (Page 6)

FORM NO. L-20183-L-1209 6
CALIPEr
refer to Figures 4 - 7.
1. Slide one Caliper Assembly over the Rotor and Hub.
NOTE
For best thermal dissipation, align the Caliper
Assembly as shown in relation to the direction of
rotor rotation. Direction of rotor rotation is stamped
in the rotor.
NOTE
remove and discard the two Hex. Nuts used to hold
the Caliper Assembly together during shipping.
2. Using Socket Head Cap Screws, Flat Washers, and
Lock Washers, secure the Caliper Assembly to the
Mounting Ring.
3. Tighten the Socket Head Cap Screws.
NOTE
On Models XTB-10, 12, 14, and 18, tighten the
Socket Head Cap Screws to 45 Ft. Lbs. [61 N•m]
torque.
On Model XTB-22, tighten the Socket Head Cap
Screws to 110 Ft. Lbs. [149 N•m] torque.
4. Repeat Steps 1-3 to install the remaining Caliper
Assemblies.
5. Slide the Rotor and Hub on the machine shaft until it
is snug against the Caliper Assemblies.
6. Tighten Set Screws.
7. Align the Mounting Ring and Calipers to the Rotor(s)
and Hub Assembly by adjusting the Nuts until a 1/16-
3/32'' spacer can be inserted between the tabs on
the Caliper and Rotor (See Figure 6 for Single Rotor
and Figure 7 for Dual Rotor alignment procedures).
8. Tighten the Hex. Head Jam Nuts to 131 Ft. Lbs. [178
N•m] torque.
FIGurE 7
DuAL rOTOr XTB ALIGNMENT
FIGurE 6
SINGLE rOTOr XTB ALIGNMENT
FIGurE 5
Socket Head
Cap Screws,
Washers, and
Lock Washers
Caliper
Assembly
rotor
and
Hub
FIGurE 4
Set Screws
INSTALLATION (continued)