Nexen FMCE 625 801683 - Manual (Page 9)

9 FORM NO. L-20319-H-1112
1
6
2
3
4
FIGURE 12
4. Fully supporting the Housing (Item 1), press the old Ball
Bearing (Item 2) out of the Housing (See Figure 12).
NOTE
Do not reuse the bearing. Applying force on inner bearing
race to remove bearing held by outer race causes damage
to the bearing.
5. Clean the bearing bore of the Housing (Item 1) with fresh
safety solvent, making sure all old Loctite residue is removed
(See Figure 12).
6. Apply an adequate amount of Loctite 680 to evenly coat
the outer race of the new Ball Bearing (Item 2) (See Figure
12).
7. Carefully align the outer race of the new Ball Bearing (Item
2) with the bore of the Housing (Item 1) (See Figure 12).
8. Supporting the Housing (Item 1) and pressing on the outer
race of the new Ball Bearing (Item 2), press the new Ball
Bearing into the Housing (See Figure 12).
9. Reinstall the Retaining Ring (Item 3) (See Figure 12).
10. Support the inner race of the new Ball Bearing (Item 2)
and press the Drive Disc (Item 4) into the new Ball Bearing
and Housing (Item 1) (See Figure 12).
11. Reinstall the Retaining Ring (Item 6) (See Figure 12).
NOTE
Proceed with PARTS REPLACEMENT–BEARINGS AND
O-RING SEALS.
MODEL 875 AND 1125
1. Remove the four Socket Head Cap Screws (Item 13) and
separate the two halves of the FMCBE (See Figure 13).
2. R e m o v e t h e f o u r S o ck e t H e a d C a p S c r e w s
(Item 27) (See Figure 14).
3. Remove the Female Pilot (Item 26) from the Housing (Item
1) (See Figure 14).
WARNING
Special attention should be exercised when working
with retaining rings. Always wear safety goggles when
working with spring or tension loaded fasteners or
devices.
4. Remove the Retaining Ring (Item 6) and press the Drive Disc
(Item 4) out of Female Pilot (Item 26) (See Figure 14).
5. Remove the Retaining Ring (Item 3) (See Figure 14).
6. Fully supporting the Female Pilot (Item 26), press the old
Ball Bearing (Item 2) out of the Female Pilot (See Figure
14).
NOTE
Do not reuse bearing. Applying force on inner bearing
race to remove bearing held by outer race causes damage
to bearing.
7. Clean the bearing bore of the Female Pilot (Item 26) with
fresh safety solvent, making sure all old Loctite ® residue is
removed (See Figure 14).
8. Apply an adequate amount of Loctite 680 to evenly coat
the outer race of the new Ball Bearing (Item 2) (See Figure
14).
FIGURE 13
13
3
4
2
1
FIGURE 14
26
6
27