Nexen F-450 802700 - Manual (Page 5)

5 FORM NO. L-20003-AA-1112
INSTALLATION
PILOT MOUNT CLUTCH
Refer to Figure 1.
1. Secure a customer supplied sheave or sprocket to the
Clutch.
2. Insert the Key (Item 18) into the shaft.
NOTE: Align the air inlet port to a down position to allow
condensation to drain out of the port.
3. Slide the Clutch onto the shaft as far as possible with
the Key (Item 18) fully seated into the Hub (Item 1)
keyway (See Table 1).
4. Install and tighten the Set Screws (Item 17) to the
recommended torque (See Table 2).
SHEAVE MOUNT CLUTCH
Refer to Figure 2.
1. Insert the Key (Item 18) into the shaft.
NOTE: Align the air inlet port to a down position to allow
condensation to drain out of the port.
2. Slide the Clutch onto the shaft as far as possible with
the Key (Item 18) fully seated into the Hub (Item 1)
keyway (See Table 3).
3. Install and tighten the Set Screws (Item 17) to the
recommended torque (See Table 4).
L E D O M N O I T A T R E S N I T F A H S M U M I N I M
W F ] m m 0 8 . 0 5 [ . n I 0 . 2
W L ] m m 0 5 . 3 6 [ . n I 5 . 2
W M ] m m 5 2 . 5 9 [ . n I 5 7 . 3
W H ] m m 0 6 . 1 0 1 [ . n I 0 . 4
TABLE 1
FIGURE 2
17
18
1
TABLE 2
L E D O M E U Q R O T G N I N E T H G I T W E R C S T E S
W F ] m • N 9 [ . s b L . n I 0 8
W L ] m • N 9 . 5 1 [ . s b L . n I 2 4 1
W M ] m • N 4 . 6 2 [ . s b L . n I 6 3 2
W H ] m • N 4 . 6 2 [ . s b L . n I 6 3 2
L E D O M E U Q R O T G N I N E T H G I T W E R C S T E S
W F ] m • N 9 [ . s b L . n I 0 8
W L ] m • N 9 . 5 1 [ . s b L . n I 2 4 1
W M ] m • N 4 . 6 2 [ . s b L . n I 6 3 2
W H ] m • N 4 . 6 2 [ . s b L . n I 6 3 2
TABLE 4
TABLE 3
L E D O M N O I T A T R E S N I T F A H S M U M I N I M
W F ] m m 0 8 . 0 5 [ . n I 0 . 2
W L ] m m 0 5 . 3 6 [ . n I 5 . 2
W M ] m m 5 2 . 5 9 [ . n I 5 7 . 3
W H ] m m 0 6 . 1 0 1 [ . n I 0 . 4
FIGURE 1
18
Customer supplied
sheave or sprocket
1
17