Nexen FMCE-130-19 801673 - Manual (Page 5)

2
FORM NO. L-20306-A-0501
INSTALLATION
MOUNTED ON THE SHAFT END OF A MOTOR
1. Insert the customer supplied key into the motor shaft
keyway (See Figure 1).
2. Slide the FMCE onto the motor shaft; then, secure it
to the motor using Socket Head Cap Screws (Item
29) and Lock Washers (Item 30) (See Figure 1).
3. Align the hole in the FMCE with the Set Screw in the
Drive Disc.
4. Tighten the Set Screw (Item 31) and then install the
Plug (Item 32) (See Figure 1).
FIGURE 1
Customer
supplied key
Motor
Set Screw
(Item 31)
Plug
(Item 32)
FMCE
FIGURE 2
Motor
Customer
supplied key
Set Screw
(Item 31)
Plug
(Item 32)
Key
(Item 25)
Customer supplied
socket head cap
screws,
lock washers, and
nuts
Gear
Reducer
FMCE
Socket Head Cap
Screws (Item 29) and
Lock Washers (Item 30)
Socket Head Cap
Screws (Item 29)
and Lock Washers
(Item 30)
1. Insert the Key (Item 25) into the output shaft of the
FMCE (See Figure 2).
2. Slide the FMCE output shaft into the gear reducer
(See Figure 2).
3. Secure the FMCE to the gear reducer using
customer supplied socket head cap screws, lock
washers, and nuts (See Figure 2).
4. Insert the customer supplied key into the motor shaft
keyway (See Figure 2).
5. Slide the motor into the FMCE and secure it to the
FMCE using Socket Head Cap Screws (Item 29) and
Lock Washers (Item 30) (See Figure 2).
6. Align the hole in the FMCE with the Set Screw in the
Drive Disc.
7. Tighten the Set Screw (Item 31) and then install the
Plug (Item 32) (See Figure 2).
MOUNTED BETWEEN A GEAR REDUCER AND A MOTOR