Nexen FMCBE-70-14 801360 - Manual (Page 7)

(1) FORM NO. L-20365-A-0699
FIGURE 1
Item 26
NOTE: Refer to Figure 1
1. Remove the Socket Head Cap Screws (Item 13) and the
Housing (Item 1).
2. Insert the Customer Supplied Key into the motor shaft
keyway.
3. Slide the Housing (Item 1) onto the motor shaft, then
secure it to the motor with the Socket Head Cap Screws
(Item 29).
4. Align the Set Screw (Item 26) in the Drive Disc (not
shown) with the hole in the Housing (Item 1).
5. Tighten the Set Screw (Item 26) and install the Plug
(Item 27). Align the FMCBE Model 70-14 air inlet ports
to the 6 o’clock down position to allow condensation to
drain out of the ports.
6. Apply a drop of Loctite® 242 to the threads of the four
Socket Head Cap Screws (Item 13) and secure the two
halves of the FMCBE Model 70-14 (Metric Face Mounted
Enclosed Clutch Brake) together.
7. Tighten the four Socket Head Cap Screws (Item 13) to
6.1-7.5 Nm (54-66 in/lbs).
NOTE: Refer to Figure 2
1. Remove the Socket Head Cap Screws (Item 13) and the
Housing (Item 1).
2. Insert the Customer Supplied Key into the motor shaft
keyway.
3. Slide the Housing (Item 1) onto the motor shaft, then
secure it to the motor with the Socket Head Cap Screws
(Item 29).
4. Align the hole in the Housing (Item 1) with the Set Screw
(Item 26) in the Drive Disc.
5. Tighten the Set Screw (Item 26) and install the Plug
(Item 27). See “NOTICE”.
6. Apply a drop of Loctite® 242 to the threads of the four
Socket Head Cap Screws (Item 13) and secure the two
halves of the FMCBE Model 70-14 together.
7. Tighten the four Socket Head Cap Screws (Item 13) to
6.1-7.5 Nm (54-66 in/lbs).
8. Insert the Key (Item 25) into the Stub Shaft (not shown).
9. Slide the Stub Shaft into the Gear Reducer.
10. Secure the FMCBE Model 70-14 to the Gear Reducer
with the customer supplied fasteners.
Item 27
Item 1
Customer
Supplied
Key
Motor
Item 29
Item 13
FIGURE 2
Item 26
Item 27
Item 1
Motor
Item 29
Item 13
Customer
Supplied
Fasteners
Gear
Reducer
INSTALLATION
MOUNTED ON THE SHAFT END OF A MOTOR
MOUNTED BETWEEN A GEAR REDUCER AND A MOTOR
Customer
Supplied
Key
Item 25