Nexen FMCBES-8-42 801481 - Manual (Page 10)

FORM NO. L-20241-G-1209 10
PARTS REPLACEMENT – HOUSING BEARING
FMCBES 110-14
Refer to Figure 8.
1. Remove the four Socket Head Cap Screws (Item 14)
and slide the Housing (Item 7), Bearing (Item 2), and
the Drive Disc (Item 4) out of the FMCBES.
8. Carefully align the outer race of the new Bearing (Item
2) with the bore of the Housing (Item 7).
9. Supporting the Housing (Item 7) and pressing on the
outer race of the new Bearing (Item 2), press the new
Bearing into the Housing.
10. Reinstall Retaining Ring (Item 3).
11. Support the inner race of the new Bearing (Item 2)
and press the Drive Disc (Item 4) into the new Bearing
and Housing (Item 7).
12. Reinstall Retaining Ring (Item 6).
13. Apply a drop of Loctite 242 to the threads of the
Socket Head Cap Screws (Item 14).
14. Slide the Housing (Item 7), Bearing (Item 2), and Drive
Disc (Item 4) into the FMCBES and reinstall the four
Socket Head Cap Screws (Item 14).
15. Tighten the four Socket Head Cap Screws to 10.5 Ft.
Lbs. [14.2 N•m] torque.
3
6
7
2
4
14
FIGURE 8
PARTS REPLACEMENT – FEMALE PILOT BEARING
FMCBES 130-19, 130-24, 7-28, 7-38, 8-38, AND 8-42
Refer to Figure 9.
1. Remove four Socket Head Cap Screws (Item 8) and
slide the Female Pilot (Item 1), Bearing (Item 2), and
the Drive Disc (Item 4) out of the FMCBES
.
4
3
2
1
6
FIGURE 9
8
2. Remove Retaining Ring (Item 6).
3. Press the Drive Disc (Item 4) out of the Bearing (Item
2) and the Housing (Item 7).
4. Remove Retaining Ring (Item 3).
5. Fully supporting the Housing (Item 7), press the old
Bearing (Item 2) out of the Housing (Item 7).
NOTE
Do not reuse the bearing. Applying force to the inner
bearing race to remove a bearing held by the outer
race causes damage to the bearing.
6. Clean the bearing bore of the Housing (Item 7) with
fresh safety solvent, making sure all old Loctite residue
is removed.
7. Apply an adequate amount of Loctite ® 680 to evenly
coat the outer race of the new Bearing (Item 2)
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.
NOTE
The following sections are arranged by model. Verify that you are in the correct section for your model.
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.