Nexen SSE-1000 822530 - Manual (Page 10)

10 FORM NO. L-20175-J-1112
PARTS REPLACEMENT
FRICTION FACINGS
NOTE: Refer to Figure 6.
1. Align the holes in the Friction Disc Hub (Item 1) with
the Machine Screws (Item 14) holding the split Friction
Facing (Item 5).
2. Remove the old Machine Screws (Item 14).
3. Remove the old split Friction Facings (Item 5).
4. Install the new split Friction Facings (Item 5).
5. Secure the new split Friction Facings (Item 5) using the
new Machine Screws (with locking patch) (Item 14).
6. Tighten the new Machine Screws to the recommended
torque (See Table 6).
TABLE 6
Recommended Tightening Torque (Item 14)
BEARING, COMPRESSION SPRINGS, AND 0-RING SEALS
NOTE: Refer to Figure 7.
1. Alternately and evenly remove the Shoulder or Socket
Head Cap Screws (Item 6).
2. Remove the Cylinder (Item 10).
3. Remove the Compression Springs (Item 7).
4. Remove the O-ring Seals (Items 11 and 12).
FIGURE 6
Align holes in
Friction Disc
Hub (Item 1)
with Machine
Screws.
Friction Facing
(Item 5)
Machine
Screw
(Item 14)
Item 1 Item 5 Item 3 Item 4 Item 8 Item 9 Item 2 Item 12 Item 11 Item 10
Item 16 Item 7
FIGURE 7
Item 13
Item 15
Item 6
Item 14 Item 13
l e d o M l e d o M l e d o M l e d o M l e d o M s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T
0 5 4 - E S S ] m N 5 . 2 [ . s b L . n I 2 2
0 0 6 - E S S ] m N 5 . 2 [ . s b L . n I 2 2
0 0 8 - E S S ] m N 7 . 6 [ . s b L . n I 0 6
0 0 0 1 - E S S ] m N 7 . 6 [ . s b L . n I 0 6
CAUTION
Shoulder and Socket Head Cap Screws
are spring loaded. Always wear safety
goggles when working with spring or
tension loaded fasteners or devices.
CAUTION
Spring Housing and Piston Plate are spring
loaded. Spring Housing and Piston Plate can
spring apart, resulting in personal injury if Spring
Housing and Piston Plate are not clamped
together.