Nexen LSCC-44 923632 - Manual (Page 6)

FORM NO. L-21099-G-1209 6
aIr COnneCTIOnS
nOTe
For quick response, nexen recommends a quick exhaust
valve and short air lines between the Control Valves and
the product. align the air inlet ports to a down position
to allow condensation to drain out of the air chambers
of the product.
CAUTION
Low air pressure will cause slippage and
overheating. Excessive air pressure will
cause abrupt starts and stops, reducing
product life.
All Nexen pneumatically actuated devices require clean
and dry air, which meet or exceeds ISO 8573.1:2001
Class 4.4.3 quality. The following are common air supply schemes used with
this product. These are examples and not an all-inclusive
list. All air circuits to be used with this product must be
designed following EN983 guidelines.
WARNING
Never exceed maximum operating
speeds listed for your product.
(See Table 2).
OPeraTIOn
TaBLe 2
CAUTION
The temperature limits for this
product line are 4.5-100 Degree
Celsius (40-220 Degree F).
CAUTION
Never exceed life of facing material. Facing
life depends on the volume of material and
the total energy over the life of the unit.
Expected life (in hrs) can be found by:
Time=Volume/(Power*Wear Rate).
Maximum rPM
PSI Size 32 Size 44 Size 54
80 300 250 250
70 400 300 300
60 550 350 350
50 800 450 450
40 1000 750 750
WARNING
Ensure proper guarding of the product is
used. Nexen recommends the machine
builder design guarding in compliance
with OSHA 29 CFR 1910 “Occupational
Safety and Health Hazards”.