Nexen LSCC-44 923632 - Manual (Page 5)

5 FORM NO. L-21099-G-1209
InSTaLLaTIOn
refer to Figure 1.
1. Secure a sheave or sprocket onto the Pilot end of the
clutch using the appropriate bolts (See Table 1).
2. Insert the onto the machine shaft.
3. Slide the LSCC onto the machine shaft..
4. Secure the Clutch to the machine shaft using the three
Set Screws (Item 16).
5. Attach the airline in the six o’clock position to avoid
water from accumulating inside.
Figure 1
16
Table 1
Model LSCC-32 LSCC-44 LSCC-54
Bolt Size 1/4 - 20 1/4 - 20 5/16 - 20
nOTe
nexen pneumatically actuated devices require clean, pressure regulated air for maximum performance and
life. all seals in nexen pneumatically operated devices are lubricated for life, and do not require additional
lubrication.
However, some customers prefer to use an air line lubricator, which injects oil into the pressurized air,
forcing an oil mist into the air chamber. This is acceptable, but care must be taken to ensure once an air mist
lubrication system is used, it is continually used over the life of the product as the oil mist may wash free the
factory installed lubrication.
Locate the lubricator above and within ten feet of the product, and use low viscosity oil such as Sae-10.
Synthetic lubricants are not recommended.
nexen product's bearings are shielded and pre-lubricated, and require no further lubrication.
LuBrICaTOr DrIP raTe SeTTInGS
1. Close and disconnect the air line from the unit.
2. Turn the Lubricator Adjustment Knob counterclockwise
three complete turns.
3. Open the air line.
LuBrICaTIOn
CAUTION
These settings are for Nexen supplied
lubricators. If you are not using a Nexen
lubricator, calibration must follow the
manufacturer's suggested procedure.
4. Close the air line to the unit when a drop of oil forms
in the Lubricator Sight Gage.
5. Connect the air line to the unit.
6. Turn the Lubricator Adjustment Knob clockwise until
closed.
7. Turn the Lubricator Adjustment Knob counterclockwise
one-third turn.
8. Open the air line to the unit.