Pilz PMCprimo 16+.00/0/1/6/4 - Manual (Page 8)

6 Description of Profibus DP
Page 8 Technical Documentation for PMCprimo Profibus DP
6.2.3 Connector X8 configured for Profibus DP-S
The setting for the Profibus parameters can be done with the “CD“ command (example in 6.3.3).
With the jumpers 1, 2 and 3 the Profibus termination can be set. To activate the termination, the
jumpers have to be set followed:
Pin Description
3 DP+
5 DP-GND
6 5
V
8 DP-
6.2.4 Using the Profibus interface (connector X8) with PMCprimo
With the Profibus DP-S up to 16 bus-variables can be read or written.
•
Notation: $B1 - $B108 (see the PMCprimo programming manual „bus variables“)
• Data bits : 16 Bit (=2 Bytes = 1 Word) signed.
• Range: -32768 to 32767 (Hex: 0x8000 to 0x7FFF).
Bus variables can be defined as trigger variables, so a program can be executed when the
variable is updated.