Pilz PSS SB TESTER D - Manual (Page 31)

Operating Manual: PSS SB TESTER 5-13
Performing the length measurement
• Add the PSS SB TESTER to SafetyBUS p as shown in Figs. 5-3 to 5-6.
• Switch on the PSS SB TESTER.
• Highlight the symbol in the “Start” window and press VAL.
• The “SafetyBUS p” window opens, in which you can select the test/
measurement. Use the arrow keys to move the cursor to the symbol for
“Length measurement” and press VAL.
• The following question is displayed: “SafetyBUS p is switched off?”.
Make sure that SafetyBUS p is switched off, i.e. all devices on
SafetyBUS p must be switched off.
On the PSS SB BRIDGE, both sides of the Bridge must be without
voltage.
• Press VAL.
When the test is complete, a measured curve appears on the display.
Fig. 5-7 shows a typical measured curve.
Fig. 5-7: Typical measured curve for length measurement