Volvo 2009 C70 - Manual (Page 149)

06 Starting and driving
Stability system
06
}}
149
Dynamic Stability Traction Control
(DSTC)
The stability system consists of a number of
functions designed help reduce wheel spin,
counteract skidding, and to generally help
improve directional stability.
A pulsating sound will be audible when the
system is actively operating and is normal.
Traction control – TC
This function is designed to help reduce wheel
spin by transferring power from a drive wheel
that begins to lose traction to the wheel on the
opposite side of the vehicle (on the same axle).
TC is most active at low speeds.
This is one of the stability system's permanent
functions and cannot be switched off.
A - thumb wheel, B - RESET button
Spin control (SC)
The spin control function is designed to help
prevent the drive wheels from spinning while
the vehicle is accelerating.
Under certain circumstances, such as when
driving with snow chains, or driving in deep
snow or loose sand, it may be advisable to
temporarily switch off this function for maxi-
mum tractive force.
Temporarily switching off Spin control
1. Turn the thumbwheel (A) on the left-side
steering wheel lever until the DSTC menu
is displayed.
2. Hold down the RESET button (B) to toggle
between DSTC SPIN CONTROL ON or
OFF .
NOTE
• The message DSTC SPIN CONTROL
OFF indicates that the stability sys-
tem's spin control function has tempo-
rarily been switched off.
•
The stability control indicator light
will illuminate and remain on until spin
control has been reactivated.
• The spin control function is automati-
cally enabled each time the engine is
started.
• DSTC ON indicates that all system
functions are active.
Active yaw control – AYC (DSTC only)
This function helps maintain directional stabil-
ity, for example when cornering, by braking
one or more of the wheels if the vehicle shows
a tendency to skid or slide laterally.
This is one of the stability system's permanent
functions and cannot be switched off.