XAIRCRAFT STELLA - Manual (Page 9)

7 ©2013 XAircraft 版权所有
Quick Guide
STELLA is currently the simplest brushless gimbal in the world. It is operational after a few short steps listed below.
1. Install the mounting components, GoPro Hero 3/3+ and connect STELLA to your receiver.
2. Configure your radio according to what type of receiver you use (Standard receiver or SBUS receiver).
3. Power on your transmitter, then power on STELLA, and wait for the systems check to finalize. This will take
approximately 10 seconds.
※
When powering on STELLA, keep GoPro as stable as possible. During the systems check any vibration or
movement to STELLA will cause the systems check to fail.
4. Check your transmitter controls are working correctly.
Troubleshooting
Symptoms Possible Reasons Solutions
10 seconds after powering on
STELLA, camera is still not levelled
or simply not responding.
There may have been some
movement or vibration when
powering-on STELLA, system check
has failed.
Keep STELLA stationary when
powering-on.
Camera keeps drifting. 1. There may have been some
movement when powering-on
STELLA.
2. The trim setting on your remote
controller is too high or
abnormal.
1. Keep STELLA stationary when
powering-on.
2. Adjust stick trim on the
controller.
Camera is not levelled after System
check.
1. STELLA is not correctly
configured.
2. STELLA is damaged.
1. Reset the initial angle in the
configuration software.
2. Contact your dealer.