WaterFurnace Envision Low Sill - Manual (Page 14)

14
ENVISION LOW SILL CONSOLE INSTALLATION MANUAL
Installation Steps cont.
Field Converting Console
Chassis is normally configured with controls on right end and piping on left end (see Figure 3 top view). In this position
panel number 1 would be positioned against wall or back plate. Unit may also be turned 180° against wall or back plate. In
this position controls will be on left end and piping on right end panel number 2 would be positioned against wall or back
plate. Chassis must be enclosed with an approved cabinet enclosure.
1. Remove 4 screws from front kick panel on cabinet.
2. Remove cabinet from chassis by lifting and sliding
cabinet straight up.
3. Remove grille assembly from cabinet by removing 4
screws from brackets located on the bottom of the grille
and door assemblies.
4. Replace grille/door assemblies into cabinet
repositioning pieces 1, 2, and 3 into the locations directly
opposite the original positions. Secure by replacing
mounting brackets. (Note: Be sure that louvers on the
grille assembly are facing the proper direction when
replacing the grille section.)
5. Replace grille/frame assembly into cabinet, and secure
by replacing mounting brackets.
6. Replace cabinet by sliding it down over the top of the
chassis.
7. Remove tab on leg that extends into return air opening.
When the grille side of the cabinet is flat against chassis
there will be 4 holes that line up in the leg section. Only
use 1 hole for alignment for opposite side of grille. (Note:
The tab can be removed by twisting back and forth until
it breaks off.)
8. Remove plastic strip from tab and replace on rough
edge that the tab was removed from.
9. Replace screws in font kick panel to secure cabinet to
chassis.
10. Mount filter bracket in designated opening area. (Note:
The filter bracket will only fit in one direction if cabinet
is installed properly.)
LEFT RETURN
RIGHT RETURN
1
3
2
7
6
5
5
4
6
7
3
4
5
5
2
1