Hi-6r – Vortech 1993-1997 5.7L LT1 F-Body User Manual

Page 7

P/N: 4GH020-010

05NOV01 v1.2

vii

Unplug the two-wire harness from the coil. Cut the

connectors off from the main harness approximately 2"
from the end.

Attach the supplied male and female connectors to the

green and pink wires previously cut from the coil
connector. Connect the pink wire to the red wire and
the green wire to the white wire coming from the
supplied ignition box.

Reattach the grey connector to the coil. Using the

supplied male and female connectors, attach the pink
wire to the orange wire (from the ignition box) and attach
the green wire to the black wire.

1996-97 GM LT1 F-BODY SUPPLEMENT

HARDWIRING INSTRUCTIONS FOR KITS NOT
EQUIPPED WITH A GM WIRING HARNESS

HEAVY RED

HEAVY BLACK

TO BATTERY +

TO GROUND

FACTORY GM

HARNESS

(UNPLUGGED

FROM COIL)

IGNITION COIL

PINK

GREEN

PINK

GREEN

CUT HERE
AND ATTACH
CONNECTOR

WIRE TAP

RED

WHITE

BLACK

ORANGE

GREEN TACH (TAPE UP)

*GREY MAGNETIC TRIGGER HARNESS (TAPE UP)

YELLOW (TAPE UP)

BLACK (GROUND)

BROWN WITH WHITE STRIPE

RED

SUPPLIED MAP SENSOR

MANIFOLD

VACUUM

3 WIRE HARNESS

RANE

ELECTRONICS

HI-6TR

TIMING RETARD CONTROL

ETARD

RANE

cams

HI-6R

CAPACITIVE DISCHARGE IGNITION

WITH AUTO-SEQUENCE REV LIMITER

*NOTE: CABLE CONTAINS RED AND BLACK
LEADS. MAKE SURE LEADS DO NOT CONTACT
EACH OTHER AND SHORT UNIT WHEN TAPING UP.