Vortech 1993-1997 5.7L LT1 F-Body - Manual (Page 26)

P/N: 4GH020-010
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
05NOV01 v1.2
(4GH V1.2)
14
A. Use the supplied 3/8-16 x 3/4" bolt to
reconnect the ground wires to the cylinder
head. Use the upper left hand hole in the
front of the driver's side cylinder head to
mount the bolt (include the small bracket
securing the 1/4" piece of plastic tubing with
the ground wires).
B. Using the two supplied 3/8-16 x 3/4" bolts,
washers and nuts, fasten the coil and ignition
module assembly to the Vortech coil bracket.
(See
Figure 13-a. )
13. COIL RELOCATION AND IGNITION BOX MOUNTING
11. OIL DRAIN HOSE
A. Connect the 1/2" x 9" drain hose from the
supercharger to the 1/2" barb in the oil pan.
Make sure that there are no dips or kinks in
the drain hose. Trim if necessary.
B. Secure both ends with the supplied #8
clamps.
I. Reinstall the plastic splash guard (previously
trimmed) into the lower left fenderwell.
10. AIR INLET DUCT, cont'd.
12. OIL FEED HOSE CONNECTION
A. Route the oil feed line up to the supercharger
and connect to the supercharger oil feed.
B. Use care to ensure that there are no kinks,
sharp bends or routing near moving objects.
Figure: 13-a