Vortech 1993-1997 5.7L LT1 F-Body User Manual

Page 23

P/N: 4GH020-010

05NOV01 v1.2

UPPER MOUNTING
BRACKET HOLES

UPPER
MOUNTING
BRACKET

REMOVE 7-1/2"
FROM THIS END

FROM
DISTRIBUTOR

ROUTE TO LEFT
SIDE INNER FENDER

FRONT

8. SUPERCHARGER MOUNTING

A. Reinstall the four driver's side spark leads

to the distributor module.

B. On 1995-97 models only, separate the

distributor ventilation hoses from the black
flex loom. Remove the vacuum hose from
the blue one-way valve (next to the throttle
body) and cut approximately 7-1/2" off of the
end. Run the line back up in between the
water pump and the upper main bracket to
the blue valve and reconnect. Temporarily
leave the remaining 5/32" fresh air hose
down below. (See

Figure 8-a

C. Attach the supplied 1/2" x 9" drain hose to

the supercharger oil drain using the supplied
#8 clamp. Rotate the clamp so that the screw
housing will not interfere with the mounting
plate when installed.

7. SUPERCHARGER MAIN BRACKETS

A. Install the lower mounting bracket to the front

driver's side of the engine block using two
3/8-16 x 1-1/4" socket head bolts supplied.
(See

Figures 7-a, 7-b

B. Install the upper mounting bracket to the

cylinder head and engine block using the
two 3/8-16 x 2-1/2" and 3/8-16 x 1-1/4"
socket head bolt. (See

Figure 7-c

Distributor Ventilation System

(1995-97 Models Only)

LOWER MOUNTING
BRACKET HOLES

LOWER
MOUNTING
BRACKET

Figure: 7-a

Figure: 7-c

Figure: 7-b

Figure: 8-a