Vortech 1993-1997 5.7L LT1 F-Body User Manual

Page 16

P/N: 4GH020-010
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
05NOV01 v1.2

(4GH V1.2)

3. CRUISE CONTROL RELOCATION

A. Using the template on page 5, mark the

splash guard located in the front lower left
side of the vehicle.

B. Remove the splash guard and cut out the

marked area for air inlet tube clearance.
(See

Figure 3-a

C. Locate the cruise control box below the

driver's side front frame rail, and remove by
disconnecting the electrical connection and
fasteners.

D. Disconnect the control box from its mounting

bracket by removing the three bolts and
splitting the plastic cable guard.

E. Rotate the unit and mount it on the side of

the frame rail using the front bolt hole of the
original bolt pattern on the frame, bolt and
front tab. Secure the two front mounting tabs
by drilling two 1/8" holes and installing the
supplied #10 x 1-1/2" sheet metal screws.
(See

Figures 3-b, 3-c

Plug the electrical connector back into the

unit (you may find it necessary to reroute
the wiring through the air intake opening to
reach the control box). Check all cables and
connections for routing and possible binding.
Use the supplied tie wraps to secure.

Fig. 3-b

Fig. 3-a

Fig. 3-c

➔