Vermona DRM1 MK2 - Manual (Page 10)

NOTE: If the DRM1 MKII is in the learn mode and doesn’t receive any midi message, the factory settings will be
restored.
It is possible to set more channels of the DRM1 MKII to the same note-on value.
This can be used for special sounds, but it can also be a possible problem source.
Factory Settings:
Channel Midi Note value
DRUM1 36 (C)
DRUM2 48 (c)
DRUM3 41 (F)
MULTI 58 (b)
SNARE 40 (E)
CYMBAL/HI HAT1 closed 49 (cis)
CYMBAL/HI HAT1 open 51 (dis)
CYMBAL/HI HAT2 closed 42 (FIS)
CYMBAL/HI HAT2 open 44 (GIS)
CLAP 39 (DIS)
Individual Outs/Inserts
Each channel of the DRM1 MKII is equipped with a separate output/insert (9), which can be used in different
ways. Deciding for the function of the jack (9) is the used cable type, or rather the plug assignment of the cable.
Use as Individual Output:
The jack (9) can be used as individual out in two different ways:
(1)
The signal of the channel that is taken from the individual out will be taken from the main outputs (11).
Therefore you need a simple mono cable:
(2)
The signal of the channel that is taken from the individual but is additionally on the main outputs (11).
Therefore you need a special stereo-mono cable:
Tip and Ring of the stereo plug have to be bridged.
Use as Insert
The plug (9) can also be used as channel insert for integrate an external effect unit (i.e. DAF-1, PH-16).
Therefore you need a so-called Y- or Insert-cable:
- Page 10 -