Velodyne Digital Drive Series - Manual (Page 30)

www.velodyne.com 24 - Digital Drive Series User’s Manual
AND REMEMBER: Use the UP, DOWN, RIGHT and LEFT directional arrow buttons that surround SELECT to
move through the fields of the setup screen, and change settings by using the SELECT button, then the UP and
DOWN arrow keys. Or, you can skip the SELECT button and change values using the SET +/- buttons.
14. when setting the low pass crossover, begin by setting the frequency and slope to the same values as
the crossover settings on your receiver/processor (for example, many units have a large/small satellite
setting). Again, consult your receiver/processor owner’s manual for more information. you will notice that
changing these values “cascades” the values out to all the presets. That is because once these values
are set, they will not normally change from preset to preset, but if later you wish to customize a specific
preset you can. An example of a crossover changed to 100Hz is shown below: