Ubiquiti Networks airFibe24 - Manual (Page 6)

Interfaces
RESET DATA AUX CONFIG LED Display
Interface Description
RESET
To reset to factory defaults, press and hold the Reset
button for more than five seconds while the unit is
already powered on.
DATA 10/100/1000 Mbps port handles all user traffic.
AUX Port for audio tone aiming.
LED Display
Digital display used for power, status, and mode
information.
CONFIG
10/100 Mbps, secured port for configuration. By
default, this is the only port that can monitor,
configure, and/or update firmware.
LEDs
Link/Act
Speed GPS
Modulation Link/Act
Speed RX Power
Master/Slave RF Link Status
4
airFiber® AF-24 Quick Start Guide