Two Notes Wall of Sound III - Manual (Page 15)

Using TORPEDO WoS III
3 Routing of the TORPEDO WoS III: mono track
If you insert the plug-in on a mono track (in other words, mono in/mono out), the channels will take the same
input and process it in parallel.
Nevertheless, as the output is mono, the PAN parameter on every channel is deactivated.
Figure 4.3: On a mono track
If you have several mono tracks, always think of the possibility of sending them to a stereo bus. For example,
you may have your left and right guitars sent to the left and right channels of one TORPEDO WoS III by simply
panning the individual tracks left and right. What you will see is that the guitars sent to the left channel of the
plug-in will be processed on the left part of the channel area on the TORPEDO WoS III, and the guitars sent to
the right channel of the plug-in will be processed on the right part of the channel area.
4 General controls
• You can change the parameters of the TORPEDO WoS III either by clicking on the controls, pointing at a
parameter and moving the mouse wheel, or double-clicking to enter a value.
• "alt"+click on a potentiometer to reset its value to the default value.
• On the "studio window", simply click on the microphone to move it around the room.
5 Input gain and output volume controls
Those potentiometers control the input gain and the output volume of
the plug-in. It is absolutely critical that you avoid any saturation of the
input or output signals or you may considerably reduce audio quality.
Two Notes Audio Engineering TORPEDO WoS III 14