Two Notes Wall of Sound III - Manual (Page 11)

Setting up the TORPEDO WoS III
Please keep in mind that the overall quality of the total sound chain is always
determined by its weakest component. The best performance will be achieved
with a perfect adaptation (impedance, level...) of your preamp or TORPEDO
WoS III’s output signal to your audio interface. Your guitar or bass preamplifier
may not deliver true line-level signals and may use either line, microphone, or
"something in-between" signals. Make sure the signal you put in the simulation
is the best one possible so you get the most out of your TORPEDO WoS III.
3 Using TORPEDO WoS III with a software or hardware amplifier emu-
lator
You may want to use TORPEDO WoS III in order to replace the speaker simulation of a plug-in or hardware
amplifier emulator. This may be a good idea, if you keep in mind the two cases you may encounter and follow
our recommendation:
1. If the amplifier emulator embeds separate pre-amplifier and power-amplifier simulations: bypass the speaker
simulation AND the power-amplifier section of the amp emulator, and switch the TORPEDO WoS III’s power-
amp simulation on.
2. If it is not possible to bypass the power-amp simulation on the Amplifier emulator, switch off the power amp
on the TORPEDO WoS III plug-in.
The two cases can be summed up as follows:
Obviously, if the speaker simulation on the amplifier emulator cannot be bypassed, we do not recommend
using that simulation with TORPEDO WoS III.
Two Notes Audio Engineering TORPEDO WoS III 10