Tenqa SP-99 - Manual (Page 15)

Conformity Declaration
fcc coMPliance StateMent
this device complies with part 15 of the fcc rules. operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
fcc id SetbiS929v
important: Changes or modifications to this product not authorized by Tenqa could void the EMC
(electromagnetic compatibility) compliance and negate your authority to operate the product. This
product has demonstrated EMC compliance under conditions that included the use of compliant
peripheral devices. It is important that you use compliant peripheral devices to reduce the possibil-
ity of causing interference to radios, televisions, and other electronic devices. This device must not
be located near other transmitters.
note: This equipment has been tested and found to comply with the limits pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
euroPean coMMunity coMPliance StateMent
The equipment complies with the RF Exposure Requirement 1999/519/EC, Council Recommenda-
tion of 12 July 1999 on the limitation of exposure of the general public to electromagnetic fields
(0- 300GHz.) This equipment meets the following conformance standards: EN 300 328, EN 301 894,
EN 301 489-17, EN 50385
euroPe—eu declaration of conforMity
A copy of the Declaration of Conformity is available at: www.Tenqa.com/euro/compliance
SP-99_InstructionManual.indd 13 7/1/09 6:30 PM