Tenqa SP-99 - Manual (Page 11)

9
vehicles: RF signals may conflict with installed or inadequately shielded elec-
tronic systems in motor vehicles. Check with the manufacturer or its representa-
tive regarding your vehicle.
electronic devices: Most modern electronic equipment is shielded from RF
signals. However, certain electronic equipment may not be shielded against the RF
signals from the SP-99.
Pacemakers: To avoid potential interference with pacemakers, persons with
pacemakers should always keep the SP-99 more than six inches from their
pacemaker when the device is turned on. Consult with a doctor about concerns
when using the SP-99 near a pacemaker. If you have any reason to suspect that
interference is taking place, turn the SP-99 off immediately.
other Medical devices: If you use any other personal medical device, consult
the device manufacturer and your physician to determine if it is adequately
shielded from external RF energy. Turn the SP-99 off in health care facilities when
any regulations posted in these areas instruct you to do so. Hospitals and health
care facilities may use equipment that is sensitive to external RF energy.
Posted facilities: Turn off the SP-99 in any facility where posted notices so
require.
iMPortant handling inforMation
notice: Failure to follow these handling instructions could result in damage to
the SP-99 or other property.
uSing connectorS and PortS
Never force a connector into a port. Check for obstructions on the port. If the
connector and port don’t join with reasonable ease, they probably do not match.
Make sure that the connector matches the port and that you have positioned the
connector correctly in relation to the port.
keePing the SP-99 within accePtable teMPeratureS
Operate the SP-99 in a place where the temperature is always between 0º and 35º
C (32º to 95º F). Battery life may be reduced in low-temperature conditions. Store
the SP-99 in a place where the temperature is always between -20º and 45º C (-4º
to 113º F). Don’t leave the SP-99 in your car because temperatures in parked cars
can exceed this range and damage sensitive internal components. When you are
using the SP-99, it is normal for the device to get warm. The exterior of the SP-99
functions as a cooling surface that transfers heat from inside the unit to the cooler
air outside.
keePing the outSide of the SP-99 clean
To clean the SP-99 unplug all cables and turn off the SP-99 (see inside this user
SP-99_InstructionManual.indd 9 7/1/09 6:30 PM