SurgeX SX-20NE-RT-AR - Manual (Page 21)

SX-20NE-RT-AR User Manual Page 20
VII. Command Line Interface (CLI) Protocol
(continued)
AutoPing Commands
Command Description Admin Fact Def
get autoping Returns all AutoPing settings currently in use. Example:
AutoPing 1 AutoPing 2
IP Address: 10.1.2.36 0.0.0.0
Frequency: 60 10
Fail Count: 3 3
Status: OK OK
Trigger Count: 0 0
--------------------------------------
Mode: Single
Action: On-Latch
Ok
Yes
set autoping < 1 | 2 > ipaddress < dotted decimal > Sets the IP address to be pinged for AutoPing 1 or 2. Yes 0.0.0.0
set autoping < 1 | 2 > frequency < 1-999 > Sets the frequency (how often the ping is sent) for
AutoPing 1 or 2 in seconds. Yes 10
set autoping < 1 | 2 > failcount < 1-999 > Sets the number of consecutive failures the AutoPings
must detect before the AutoPing considers the pinged
device to be failed. Yes 3
set autoping mode < single | and | or > Sets single AutoPing (AutoPing 1) or two AutoPing
relationship AND or OR. Yes AND
set autoping action < none | on-latch | on-follow | off-latch |
off-follow | cycle | cycle-once >
Sets the action to be performed when the AutoPing is
triggered. Yes None
User Commands
Command Description Admin Fact Def
set password < user | admin > < old > < new > < repeat > Sets the password of the User or Administrator. Yes user | admin