StorCase Technology 14-Bay 4U SCSI Ultra160 - Manual (Page 27)

18 InfoStation User Interface
StorCase Technology, Inc. InfoStation 14-Bay User's Guide - Rev. C01
SAF-TE Processor Board SCSI ID Set-Up
The following steps show how to change the SAF-TE processor board SCSI ID.
NOTES: Only necessary if the optional SAF-TE processor board is installed.
Factory default SAF-TE Processor Board SCSI ID is 15.
Press CANCEL at anytime to exit the menu system and return to the Default
Display. The menu system will automatically cancel after 15 seconds of
User inactivity.
NOTE: The SAF-TE processor board SCSI ID can be changed anytime. However,
it will only take effect after a system power up.
1. Press ENTER at the Default Display so that
display = Status.
2. Press DOWN until display = SAFT Cfg.
3. Press ENTER so that display = SCSI ID.
4. Press ENTER again so that display = SAFT1:xx.
This is the current SAF-TE SCSI ID.
5. Press UP or DOWN to change the SAF-TE pro-
cessor board SCSI ID.
6. Press ENTER to accept the change.