StorCase Technology InfoStation 12-Bay 4U Ultra320/SATA - Manual (Page 12)

InfoStation 12-Bay RAID Installation Guide - B00 StorCase Technology, Inc.
Installation 7
Figure 5: Removing the Access Panel
Removing the Chassis Access Panel
CAUTION: Remove ALL power from the InfoStation before removing the access
panel(s). The InfoStation contains NO USER SERVICEABLE PARTS
inside the unit. Warranty is VOID if any of the modules inside the
InfoStation are opened. Refer ALL servicing to qualified service
personnel!
NOTE: A #2 Phillips screwdriver will be required for this procedure.
1.Unplug the InfoStation and verify that ALL cables have been disconnected.
2.Place the InfoStation on a soft clean surface to protect finish of the chassis.
3.Remove the ten (10) #6-32 Phillips Flat Hd.
screws securing the access panel to
the InfoStation chassis (Figure 5).
4.Remove the access panel by carefully lifting the panel(s) off the chassis (Figure 5).
5.To reinstall panel, simply reverse the above mentioned steps.
Access Panel
(Right Side)
#6-32 Phillips
Flat Hd. Screw
(10 total)
InfoStation
Chassis