StorCase Technology InfoStation 12-Bay 4U Ultra320/SATA - Manual (Page 10)

InfoStation 12-Bay RAID Installation Guide - B00 StorCase Technology, Inc.
Installation 5
Figure 3: Removing the Power Supply Module
Removing/Installing the Power Supply Module
CAUTION: The power supply module contains NO USER SERVICEABLE PARTS inside
the unit. Warranty is VOID if module is opened. Refer ALL servicing to
qualified service personnel!
This unit has more than one power supply cord. Disconnect two power
supply cords before servicing to avoid electric shock.
NOTES: The power supply module is hot-swappable. The chassis may remain on
when removing and installing the module.
Blank plate (provided) must be installed if module slot is left empty. Instal-
lation of the blank plate is necessary for proper cooling inside chassis.
A #2 Phillips screwdriver will be required for this procedure.
1.Turn OFF power to the power supply module via the power switch located on the
chassis.
2.Press the release lever securing the power supply module to the InfoStation chassis
(Figure 3).
3.Remove the power supply module by grasping handle and pulling out from chassis.
4.To reinstall power supply module, simply insert until module 'clicks' into place.
Power Supply
Module
Release
Lever
Module
Handle