StorCase Technology DS351 - Manual (Page 15)

DS351 User's Guide - Rev. B02 StorCase Technology, Inc.
Installation 7
Drive Preparation
1. Remove the drive from its protective packaging.
2. SCSI Drive Termination - The last drive on any SCSI channel must have termination
enabled. In most instances, depending upon cable configuration, termination will be
handled by an external terminator on the DS351 back panel. If using an external
terminator, disable onboard termination. Refer to the documentation provided by the
drive manufacturer for the location of these terminators or jumpers. External active
termination is recommended for best SCSI performance (terminator not included with
the DS351).
Removing the Drive Bracket
NOTE: Removal of the access panel (Figure 5) and drive bracket (Figure 6) is required in
order to install the drive(s). Once the drive(s) are installed into the bracket the entire
drive/bracket assembly can then be installed into the chassis.
1. Remove the access panel (Figure 5).
2. Remove the four (4) screws securing the drive bracket to the chassis (Figure 6).
3. Remove the drive bracket from the chassis by carefully lifting the rear of the bracket
out first.
Figure 6: Removing the Drive Bracket