StorCase Technology DE400 - Manual (Page 16)

8 Installation
StorCase Technology, Inc. DE400 User's Guide - Rev. B00
Figure 5: Drive Installation Assembly
Drive
Carrier
Serial ATA Drive
(Not Included)
Bottom-mount
with four (4)
Phillips Flat Hd.
Screws (Included)
Installation
1. Carefully insert the drive into the carrier. Slide the drive towards the Drive Carrier
Board, so that the I/O connector on the drive mates with the connector on the Drive
Carrier Board. Drive(s) must be bottom-mounted into the drive carrier(s) using four
(4) Phillips Flat Hd. screws (Figure 5).
NOTE: The Parallel ATA DE400 carrier has a DC Power Cable that must be
connected prior to mating with the Drive Carrier Circuit Board.
2. After the drive(s) have been installed in to the drive carrier(s), carefully insert the
carrier(s) back into the chassis (refer to section "Inserting a Drive into the Chassis"
for further information).