StorCase Technology DE400 - Manual (Page 15)

DE400 User's Guide - Rev. B00 StorCase Technology, Inc.
Installation 7
INSTALLATION
NOTES: For Serial ATA (1.5Gbps) operation, a Serial ATA controller and appropriate
Serial ATA cable are required.
A mounting bracket (not included) may be required for the installation of the
DE400. Refer to your chassis manufacturer’s documentation for further in-
formation.
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
SATA Drives
• Remove the drive from its protective packaging.
• If the drive came equipped with a plastic front bezel, it must be removed.
PATA Drives
• Remove the drive from its protective packaging.
• If the drive came equipped with a plastic front bezel, it must be removed.
• Configure the drive jumper setting to Cable Select before installing into PATA
DE400 carrier.
In most cases, the drive will be factory-configured as a Master Drive using a
jumper option on the drive itself. StorCase however, recommends reconfiguring
the drive to Cable Select instead. This can be done by configuring the jumper
option on the drive itself (refer to the drive manufacturer's documentation for
further information).