StorCase Technology DE200 Ultra320 - Manual (Page 19)

StorCase Technology, Inc. Ultra320 DE200 User's Guide - Rev. A01
12 Installation
6. To connect the drive to a Remote Activity LED in the computer system or expansion
chassis, connect the appropriate cable(s) to W1 Pins 9 & 10 on the receiving frame
motherboard as shown in Figure 5.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1 indicator
on the cable must be properly aligned. Refer to Figure 5 for the correct Pin 1 location.
NOTE: No onboard termination is provided on the DE200. External termination
must be provided.
8. Connect the power cable from the DC power supply in the computer or expansion
chassis to the power connector on the DE200 receiving frame. Refer to Figure 5 for
the DE200 receiving frame power connector location.
9. Replace any expansion boards that may have been removed earlier. Replace the
system cover according to the manufacturer’s instructions.
10. Reconnect any system or peripheral cables removed earlier.
11. Turn ON power to the computer. If the installation has been successful, and all cables
have been properly attached, the system should boot normally. Although the computer
may not recognize the DE200 yet, the appropriate front panel LED indicators should
illuminate.
NOTE: The lock on the DE200 receiving frame functions as a lock and a DC
power switch for the carrier unit. The lock must be engaged (turned
counterclockwise) in order to supply power to the carrier and installed
drive unit.
12. The new drive may need to be formatted or initialized prior to use with the operating
system and applications software. Refer to the drive and/or com-puter manufacturer's
documentation for formatting information.
Selecting the Unit ID Number
1. Verify that power is turned ON to the DE200 receiving frame by turning on the computer
or external expansion chassis. A number should appear in the unit ID display window
if the carrier is locked in place.
2. Unlock the DE200 drive carrier and remove it from the receiving frame. A "u" will be
displayed initially when the unit is unlocked but will return to a number when the carrier
is removed from the receiving frame.