StorCase Technology S20A108 - Manual (Page 19)

StorCase Technology, Inc. S20A108 User's Guide - Rev. A02
12 Installation
6. To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to W1 Pins 9 & 10 on the
receiving frame motherboard as shown in Figure 5.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1
indicator on the cable must be properly aligned. Refer to Figure 5 for the correct
Pin 1 location.
NOTE: No onboard termination is provided on the DE200. External
termination must be provided.
8. Connect the power cable from the DC power supply in the computer or expansion
chassis to the power connector on the DE200 receiving frame. Refer to Figure
5 for the DE200 receiving frame power connector location.
9. Replace any expansion boards that may have been removed earlier. Replace
the system cover according to the manufacturer’s instructions.
10. Reconnect any system or peripheral cables removed earlier.
11. Turn ON power to the computer. If the installation has been successful, and all
cables have been properly attached, the system should boot normally. Although
the computer may not recognize the DE200 yet, the appropriate front panel LED
indicators should illuminate.
NOTE: The lock on the DE200 receiving frame functions as a lock and a DC
power switch for the carrier unit. The lock must be engaged (turned
counterclockwise) in order to supply power to the carrier and
installed drive unit.
12. The new drive may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or com-puter
manufacturer's documentation for formatting information.
Selecting the Unit ID Number
1. Verify that power is turned ON to the DE200 receiving frame by turning on the
computer or external expansion chassis. A number should appear in the unit
ID display window if the carrier is locked in place.
2. Unlock the DE200 drive carrier and remove it from the receiving frame. A "u"
will be displayed initially when the unit is unlocked but will return to a number
when the carrier is removed from the receiving frame.