Installation, Installing the drive into the carrier preparation – StorCase Technology S20A108 User Manual
Page 14

S20A108 User's Guide - Rev. A02
StorCase Technology, Inc.
Installation
7
INSTALLATION
Installing the Drive into the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE:
A #2 Phillips screwdriver will be required during this procedure.
1.
Remove the drive from its protective packaging.
2.
Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3.
SCSI Drive Termination: The DE200 does not provide onboard termination.
External termination must be provided. Refer to the documentation provided by
the drive manufacturer for termination information.
4.
ID Select Jumpers: Locate the ID select jumper positions on the drive, and
remove any jumper plugs in this area ( the S20A108 drive carrier board will plug
into this section of the drive).
Installation
1.
Carefully insert the drive into the carrier. Slide the drive towards the Drive Carrier
Board, so that the I/O, DC power, and ID select connectors on the drive mate with
their respective connectors on the drive carrier board (Figure 6).
NOTE:
The S20A108 carrier supports most 68-pin SCSI Ultra160 interfaces, except
Fujitsu Alegro 6 10K RPM drives (these drives have different spacing between
the 68-pin and DC power connectors and will not mate with the drive carrier
board).
2.
Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. screws (Figure
6).