StorCase Technology S20A102 - Manual (Page 26)

S20A102 User's Guide - Rev. A01 StorCase Technology, Inc.
Appendix B - Factory-Installed Options 19
1. Remove jumpers on J3 Pins 7 & 8, and Pins 9 & 10 from the receiving frame motherboard
(Figure B-2).
NOTE: Save these jumpers! These jumpers are required when the Isolator/
Repeater Board is not installed.
2. Remove the two (2) screws on the receiving frame motherboard.
NOTE: Save these screws for Step 5!
3. Attach two (2) stand-offs (included) to the mounting holes on the receiving frame
motherboard (Figure B-3).
4. Carefully align the connectors of the Isolator Board with the connectors on the
receiving frame motherboard and gently push the board into position. Make certain that
all connectors are properly mated.
5. Secure the board to the receiving frame stand-offs with the same two (2) screws from
Step 2 (Figure B-3).
DX1/200-SWC160/RH
Isolator Board
DX1/200-SWC160/RH
Isolator Board Detail
DE100 or DE200
(Ultra160 Only)
Receiving Frame
Motherboard
0501b
Figure B-1: Isolator/Repeater Board Details