StorCase Technology S20A102 - Manual (Page 18)

S20A102 User's Guide - Rev. A01 StorCase Technology, Inc.
Installation 11
Figure 8: Receiving Frame Mounting Holes
5. Adjust the front of the receiving frame so the carrier slides freely in and out on
the receiving frame guides. The position of adjoining peripheral units may require
adjustment.
6. To connect the drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to W1 Pins 9 and 10 on the
receiving frame motherboard as shown in Figure 5.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1
indicator on the cable must be properly aligned. Refer to Figure 5 for the correct
Pin 1 location.
NOTE: No onboard termination is provided on the DE100. External
termination must be provided.
IMPORTANT NOTE: In order to use remote ID selection from a computer or expansion
chassis, the Unit ID number on the DE100 receiving frame must
be set to "0" with the provided alignment tool. Refer to the section
"Selecting the Unit ID Number" later in this manual for the Unit
ID selection procedure.
4. With the drive carrier locked in place inside the receiving frame, install the DE100
into the 5.25” drive opening in the computer or expansion chassis. Use the
appropriate guides to position the DE100, and fasten it into place with the four
(4) #6-32 x 1/4” screws provided. Figure 8 illustrates the location of the mounting
holes. Mounting holes are provided on each side and the bottom of the receiving
frame to accommodate a variety of mounting configurations. Use the mounting
holes which best suit the computer or expansion chassis configuration.
Mounting
Holes (Right)
Mounting
Holes (Bottom)
Front of Unit
Mounting
Holes (Left)
0086b