StorCase Technology DE100i-SWCU2 User Manual

Page 18

Installation

DE100i-SWCU2 User's Guide - Rev. B02

StorCase Technology, Inc.

Figure 8: Receiving Frame Mounting Holes

Adjust the front of the receiving frame so the carrier slides freely in and out on

the receiving frame guides. The position of adjoining peripheral units may require

adjustment.

To connect the drive to a remote activity LED in the computer system or ex-

pansion chassis, connect the appropriate cable(s) to option Pins 9 & 10 on the

receiving frame motherboard Option Pin Connector as shown in Figure 5.

Connect the I/O cable from the host adapter to the receiving frame. The Pin 1

indicator on the cable must be properly aligned. Refer to Figure 5 for the correct

Pin 1 location.

NOTE:

Make sure that only the last SCSI device is terminated. No

onboard termination is provided on the DE100i-SWCU2. External

termination must be provided.

With the drive carrier locked into place inside the receiving frame, install the

DE100i-SWCU2 receiving frame into the drive bay in the computer orexpansion

chassis. Use the appropriate guides to position the DE100i-SWCU2, and fasten

it into place with the four (4) #6-32 Phillips Pan Hd. screws provided. Figure 8

illustrates the location of the mounting holes. Mounting holes are provided on

each side and the bottom of the receiving frame to accommodate a variety of

mounting configurations. Use the mounting holes which best suit the computer

or expansion chassis configuration.